• Aquastats
• Automatic ignition system components
• Belts and pulleys
• Blower motors*
• Blower wheels
• (direct drive only)
• Burners (main)
• Burners (pilot)
• Capacitors
• Circulator motors, couplers, and motor mounts (no water involved)
• Condensate pumps
• Conversion burner motors*
• ECO safeties
• Electric switches
• Fan and limit controls
• Fusible links
• Gas appliance pressure regulators
• Gas A valves
• Gas B valves
• Gas controls
• Gauge glasses and associated hardware
• Induced draft motor assemblies
• Internal wiring
• Low water cut-off controls (steam systems only)
• Pilot and burner tubing
• Pilot generator cartridges
• Pilot safeties
• Power burner motors*
• Pressure relief valves (steam systems only)
• Y Pressure switches
• Spill switches
• Standard area/room thermostats** (remote temperature sensors are not included)
• Steam pressure controls and siphons
• Switching relays
• Thermocouples
• Thermostat back plates
• Thermostat batteries (hard wired only)
• Transformers
• Vent dampers
• Zone valve operators (no water involved)

• Accessory components, such as humidifiers and electronic air filters
• Automatic water feed valves and controls for steam boilers
• Back flow preventers
• Belt drive blowers
• Blower bearings
• Domestic water supply valves
• Forced air zoning system components (damper assemblies, motors, control panels, etc.)
• Heat exchangers
• Hydronic T&P gauges
• Inaccessible components
• Mixing valve
• Parts for hot water boilers that are in direct contact with water (relief valves, expansion tanks, circulator pumps, pressure reducing valves, etc.). Note: this is not applicable with a Premier Hot Water Boiler plan.
• Purging radiators of air
• Radiant heat control valves
• Repair, replacement, or cleaning of domestic hot water coils, mixing valves, shutoff valves, and associated piping
• Repair of water leaks on distribution or radiation piping
• Repair of water leaks originating in the boiler vessel or its sections
• Smart control systems intended to manage energy use for entire dwelling
• Vacuum breaker
• Vent pipes
• Water leaks, cracks, or rupture of the boiler and/or boiler sections *

NOTE: If a part covered under your Residential Natural Gas Furnace Plan is replaced while in use as a component of an electric central air conditioner, you will be charged the current diagnostic fee for the air conditioning service call. However, if you have also purchased an Air Conditioning Plan, there will be no diagnostic fee, and covered parts will be replaced in accordance with the terms of your Plan.

• Heat pump systems
• Resistive (baseboard) heating and/or space saving heating units of any type

• Routine inspections or normal preventive maintenance such as: cleaning and/or replacing air filters; adjusting air registers; cleaning or balancing ductwork; lubricating motors or other moving parts; maintenance cleaning of blower wheels, gauge glasses, and low water cutoffs; except as noted, draining expansion tanks; bleeding air from radiators; purging or topping off hot water heating systems; equipment cleaning; removing dryer lint, and/or any preventive maintenance required by the manufacturer.
• Except otherwise noted, materials and labor for any service in addition to those specified in the Plan, such as sheet metal work, plumbing repairs, leak repairs to house piping, electrical wiring repairs, and equipment relocation.
• Repairs necessary due to negligence, theft, misuse, abuse, vandalism, or lack of normal preventive maintenance.
• Failures caused by fire, freezing, water damage, power supply outages, floods, acts of nature, or any other conditions beyond the reasonable control of PSE&G.
• Repairs necessary due to faulty equipment design, improper installation, or work done by anyone other than PSE&G.
• Commercial applications of all equipment. This includes gas furnaces and boilers and/or electric central air conditioning units supplying four or more families.
• Gas central heating turn-on from Labor Day through October 31st.
• Installation of new or replacement equipment.
• Appearance and trim parts, finish defects, rusting, corrosion, chipped porcelain and porcelain flaws, exterior housings, or component failure caused by rust or corrosion.
• Parts that are no longer available, and for which no reasonable replacement exists.
• Replacement parts not listed in the WorryFree brochure.
• Priority service. Our response times vary by seasonal demands and by the nature of the problem. Twenty-four hour response time is not guaranteed.
• Preexisting conditions. Equipment must be in good working condition on the effective date of coverage.
• Reimbursement for work done by others. Parts and services not covered may be supplied, repaired, or replaced for a fee in accordance with PSE&G’s present procedures. They may also require service from an independent contractor at your expense.

• See our WorryFree brochure to view the complete terms and conditions.